Copper refrigerant lines
Service

Defrost System Repairs — Gauteng

Repair of electric, hot-gas and reverse-cycle defrost systems to clear iced evaporators and restore airflow and temperature.

Technical Datasheet

Diagnostic Process

The structured sequence we follow on every defrost repairs call — to isolate the root cause, not just the symptom.

  1. 01Confirm defrost cycle count, duration and termination method
  2. 02Test defrost heater continuity and earth leakage
  3. 03Check defrost termination thermostat / sensor
  4. 04Inspect drain line and drain heater for ice blockage
  5. 05Verify fan delay and restart after defrost
  6. 06Review controller defrost schedule against load and humidity
Take Action

Speak to a Reyds Technician

Cold chain failure costs stock by the minute. Call or WhatsApp now — a technician is dispatched to your suburb and interim holding steps are confirmed on the phone.

Call 069 268 0988 WhatsApp 069 268 0988
Emergency Cold Room Repairs Gauteng
Call or WhatsApp 069 268 0988
Email info@reyds.co.za
Defrost System Repairs · Incident Report

Leads sent to info@reyds.co.za · Prefer to call? 069 268 0988

FAQ

Frequently Asked Questions

Why is ice building up on my evaporator coil?

Failed defrost heaters, a faulty terminator, blocked drain, or excessive door opening all cause ice bridging. We find the specific cause.

How often should a freezer defrost?

It depends on load and door traffic — typically 4 to 6 cycles per day. We set the schedule to your actual operating pattern.

Can you repair hot-gas defrost systems?

Yes. We service electric, hot-gas and reverse-cycle defrost on commercial low-temperature systems.